[meta-xilinx] [PATCH 6/7] zcu102-zynqmp: Use 'rev 1.0' U-Boot config and deploy boot.bin
luca at lucaceresoli.net
Tue Oct 10 03:45:17 PDT 2017
Hi Mike, Nathan,
On 09/10/2017 12:43, Mike Looijmans wrote:
> On 09-10-17 11:23, Luca Ceresoli wrote:
>> Hi Nathan,
>> What's the current status of U-Boot SPL on zynqmp? Last time I checked
>> it appeared not yet ready for a complete Linux boot, because it cannot
>> pass the configuration object to the PMU firmware.
>> - Can U-Boot SPL boot a complete Linux without FSBL on zcu102?
>> - How much that applies to other zynqmp chips and boards (especially
> I worked around it by building the config object into the pmufw:
> The data is already there, all that's needed is a line of code that
> installs it.
Interesting, thanks! It's really a small patch, I will certainly test it.
On which board/silicon did you test it?
> This also gets around the licensing issue, the config object is not GPL
> compatible, so including it into u-boot code poses a challenge in itself.
Sure. And I agree with Nathan it seems a good solution also from a
technical point of view.
More information about the meta-xilinx