[meta-freescale] Driver Problng problem!

berlinjoevince at yahoo.com berlinjoevince at yahoo.com
Mon Jul 18 03:52:59 PDT 2016

I am currently working on Smarc-samx6i board developed by KONTRON. and i am using Linux kernel 3.10.17. Now I am trying to interface ft5x06 with my board for that I modified the device tree as 

I am using  git://git.freescale.com/imx/fsl-arm-yocto-bsp.git-b imx-3.14.28-1.0.0_ga 
polytouch: edt_ft5x06 at 39 {
             compatible = "edt","edt_ft5x06","edt-ft5x06";
             reg = <0x39>;
             pinctrl-names = "default";
             pinctrl-0 = <&pinctrl_smx6_i2c1_gpio>;
             irq_pin=<&gpio3 10 GPIO_ACTIVE_HIGH>;
             interrupt-parent = <&gpio3>;
             interrupts = <10 8>;
and i am getting the following messages after modprobe is used for inserting my module as shown below 

i2c 2-0039: uevent
i2c i2c-2: client [edt_ft5x06] registered with bus id 2-0039
i2c i2c-2: new_device: Instantiated device edt_ft5x06 at 0x39
i2c 2-0039: uevent
i2c 2-0039: uevent
i2c-core: driver [edt_ft5x06] registered
i2c 2-0039: uevent
i2c 2-0039: uevent

but the device is not appeared on /proc/bus/input/devices and interrupt also not listed in /proc/interrupts

Any suggestion where I missed 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.yoctoproject.org/pipermail/meta-freescale/attachments/20160718/22a3df7a/attachment.html>

More information about the meta-freescale mailing list