Not specifically. "bitbake -u hob" should let you see where things are at. Please keep in mind that its under active development at the moment and can be considered "alpha" quality but feedback is

I think he means partitioned uimages where you have a kernel + initrd in a single uimage. We don't support that *yet*, but all the needed blocks are there. And we finally get a usecase for having the

I'm not 100% where the list is, but I can confirm that uImages are supported and work nicely. Assuming that you are talking about the common use case, and not something more exotic

Are there any docs for hob at this point? - k

Is there a list of which IMAGE_FSTYPES are supported. I didn't see anything in the docs. Looking to see if a u-boot 'mkimage' wrapped set of images is supported or not. - k

The pieces in poky's documentation directory are part of the yocto-docs repo which is maintained by Scott (cc'd). Scott is a tech writer rather than a developer and loves git, er, I mean we might need

i thought as much, i'm going with that. not high on any list of priorities but while i'm perusing the docs, i might as well make notes of what can change, and submit patches for the more obvious

I guess it could have been so certain parts appeared in bold but I suspect there isn't a good reason. Cheers, Richard

I think we've been leaning towards BitBake for a while. Cheers, Richard

Agreed: The man page: BitBake - simple tool for the execution of tasks The user manual: BitBake User Manual Those seem like the two lines of documentation that are most likely to be correct :-) So

new version diff --git a/oe-init-build-env b/oe-init-build-env index 77332a7..0fe1b5e 100755 --- a/oe-init-build-env +++ b/oe-init-build-env @@ -39,6 +39,35 @@ else

Hi all, This is the weekly test report for Yocto 1.1 M2 RC2 20110708 build. Since all lsb build failed on autobuilder, jasperforest testing is performed against sato-sdk. There are 5 new bugs found

You are right, I will fix it. -- 倪庆亮 TEL: 13588371863 E-MAIL: niqingliang@... BLOG: http://niqingliang2003.wordpress.com

I believe it's the latter, at least that's what I've always use. Joshua -- Joshua Lock Yocto Project "Johannes factotum" Intel Open Source Technology Centre

Add CONNECTIVITY_CHECK_URIS to run the network connectivity sanity test for http, https and git sources. The variable is soft-assigned so that it's easily overrideable. Signed-off-by: Joshua Lock

Add CONNECTIVITY_CHECK_URIS to run the network connectivity sanity test against http, https and git sources for Poky derived distrbutions. The following changes since commit

I was being stupid both when I submitted this patch and when we discussed it, the poky.conf file is inherited by each of the distributions in meta-yocto so it makes sense to define this

Would this not be better in a distro config file? conf/distro/poky.conf comes to mind. Josh pointed out that the lsb variant would then miss out - so perhaps a network-sanity.inc file could be

Before searching manually, we should attempt to use whatever is set in the environment. -- Darren -- Darren Hart Intel Open Source Technology Center Yocto Project - Linux Kernel

Signed-off-by: Robert P. J. Day <rpjday@...> --- i'm hoping the following is correct -- it's just user help output so it's not fatal but it should still be correct. diff --git