Re: Specified SDKMACHINE value is not valid


jchludzinski
 

I’m actually trying this on an RP4 running Raspbian.

On 2022-04-02 12:15, Khem Raj wrote:
On Sat, Apr 2, 2022 at 1:47 AM jchludzinski <jchludzinski@...> wrote:
$ git clone git://git.yoctoproject.org/poky.git
$ cd ./poky
$ git checkout yocto-3.4.2
$ cd ..
$ source ./poky/oe-init-build-env
$ cd ./build
$ time bitbake core-image-minimal
...
ERROR: OE-core's config sanity checker detected a potential misconfiguration.
Either fix the cause of this error or at your own risk disable the checker (see sanity.conf).
Following is the list of potential problems / advisories:
Specified SDKMACHINE value is not valid
Summary: There was 1 WARNING message shown.
Summary: There was 1 ERROR message shown, returning a non-zero exit code.
________________________________________________________
Executed in 3.92 secs fish external
usr time 1.07 secs 9.77 millis 1.06 secs
sys time 0.18 secs 2.96 millis 0.17 secs
On 2022-04-01 18:09, Khem Raj wrote:
On Fri, Apr 1, 2022 at 2:02 PM jchludzinski <jchludzinski@...> wrote:
But obviously commented out.
On 2022-04-01 16:43, jchludzinski via lists.yoctoproject.org wrote:
There's this:
#SDKMACHINE ?= "i686"
OK it should be ok then. Can you describe your steps to setup the system?
maybe there is some caveat
---John
On 2022-04-01 16:22, Khem Raj wrote:
On Fri, Apr 1, 2022 at 1:09 PM jchludzinski via
lists.yoctoproject.org
[1 [1]] <jchludzinski=vivaldi.net@...> wrote:
I'm trying an experiment building yocto/OE on a Raspberry Pi 4 to
host on the same RP4. Admittedly, a not practical platform for
this
purpose but it should work.
I'm trying to target the ARM ISA for the image using yocto-3.4.2.
I've tried simply using the default setting and end up with:
_ERROR: OE-core's config sanity checker detected a potential
misconfiguration._
_ Either fix the cause of this error or at your own risk
disable
the checker (see sanity.conf)._
_ Following is the list of potential problems / advisories:_
_ _
_ Specified SDKMACHINE value is not valid_
I've tried editing ./conf/local.conf:
MACHINE ?= "qemuarm64"
#MACHINE ??= "qemux86-64"
It's complaining about SDKMACHINE setting which is a separate
variable, can you check your local.conf if it's set to something
But this accomplishes nothing. Needless to say, I'm a yacto/OE
newbie, so any suggestions would be greatly appreciated.
are you on a x86_64 host? Secondly try to uncomment SDKMACHINE setting
in local.conf
and see if it helps. Also check if your default shell is bash or dash.

---John
Links:
------
[1] http://lists.yoctoproject.org
Links:
------
[1] http://lists.yoctoproject.org
--
NULL

Join yocto@lists.yoctoproject.org to automatically receive all group messages.