Re: Specified SDKMACHINE value is not valid

Josef Holzmayr

(re-adding list as I messed up)

Am Mo., 1. Nov. 2021 um 21:45 Uhr schrieb jchludzinski

I want to build this image for a Raspberry Pi, which means ARM.
MACHINE = "raspberrypi3"
(for example, pick your specific one like

Is that not possible?

That can't be true!
Building the SDK for an architecture other than x86 is not supported
at the moment. But again, this is about the SDK. And you probably just
want to build the image, where the standard procedures apply. Add the
BSP layer, set MACHINE.


On 2021-11-01 05:55, Josef Holzmayr wrote:
jchludzinski via [1]
<> schrieb am Mo., 1.
Nov. 2021, 07:27:

NEWBIE question!

I tried building and I get: "_Specified SDKMACHINE value is not

pi@raspberrypi ~/p/build> bitbake core-image-minimal
DeprecationWarning: Using or importing the ABCs from 'collections'
instead of from '' is deprecated, and in 3.8 it will
stop working
from collections import Mapping
WARNING: Host distribution "raspbian-10" has not been validated with
this version of the build system; you may possibly experience
unexpected failures. It is recommended that you use a tested
ERROR: OE-core's config sanity checker detected a potential
Either fix the cause of this error or at your own risk disable
the checker (see sanity.conf).
Following is the list of potential problems / advisories:

Specified SDKMACHINE value is not valid

Summary: There was 1 WARNING message shown.
Summary: There was 1 ERROR message shown, returning a non-zero exit
I've tried setting SDKMACHINE to 'arm' and 'qemuarm' but get the
same message?
SDKMACHINE only accepts x86, in either 32 or 64 bit variants, see

Obviously I failed to do something (properly)?



Join to automatically receive all group messages.