Re: Does Edison work with Beagleboard & linux-yocto-3.0 kernel?
|
Jack Mitchell <ml@...>
On 11/01/12 15:20, Brian Hutchinson wrote:
On Wed, Jan 11, 2012 at 9:57 AM, Bruce Ashfield <bruce.ashfield@...> wrote:It will. I sent patches recently to make that the preferred version in the master branch. Cherry picking that change would probably be all you would need.2. Is the example for setting up for kernel modification in the development manual still valid for Edison?Should be.Would I get that change if I just did a git pull or do I have to do something else? I did a git pull to update my Edison checkout last night realizing that I hadn't done one in a while and then ran a new clean build and still ran into the same problem. After triple checking my work I figured it was time to post. Regards, Brian _______________________________________________ yocto mailing list yocto@... https://lists.yoctoproject.org/listinfo/yocto I can chime in here. I am currently trying to get my Beagleboard running on the master branch, and it is pulling in kernel 3.0.12. However I cannot get it to boot, I get as far as here: Texas Instruments X-Loader 1.5.0 (Jan 11 2012 - 14:06:12) Beagle xM Reading boot sector Loading u-boot.bin from mmc U-Boot 2011.06 (Jan 11 2012 - 14:15:11) OMAP3630/3730-GP ES2.1, CPU-OPP2, L3-165MHz, Max CPU Clock 1 Ghz OMAP3 Beagle board + LPDDR/NAND I2C: ready DRAM: 512 MiB NAND: 0 MiB MMC: OMAP SD/MMC: 0 *** Warning - readenv() failed, using default environment In: serial Out: serial Err: serial Beagle unknown 0x02 No EEPROM on expansion board Die ID #0ed800229ff800000163810c15007017 Hit any key to stop autoboot: 0 SD/MMC found on device 0 reading uEnv.txt ** Unable to read "uEnv.txt" from mmc 0:1 ** reading uImage 3106580 bytes read Booting from mmc ... ## Booting kernel from Legacy Image at 82000000 ... Image Name: Linux-3.0.12-yocto-standard+ Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 3106516 Bytes = 3 MiB Load Address: 80008000 Entry Point: 80008000 Verifying Checksum ... OK Loading Kernel Image ... OK OK Starting kernel ... Uncompressing Linux... done, booting the kernel. Where it hangs and won't go any further. I am watching it over serial using a baud rate of 115200. It's a bit worrying that uBoot doesn't pick up the Beagle revision... I'm sure it used to when I was doing testing a few months ago. Cheers, Jack. |
|
|