Re: e100 driver does not build
Saxena, Rahul <rahul.saxena@...>
Yes, the problem was due to missing dependent options..toggle quoted messageShow quoted text
I had incorrectly assumed that dependent options would get pulled in
or perhaps a error would be generated.
It worked after I added following 3 options stated as dependent options
in a Kernel configuration database that I saw:
I am still iterating to check if all three of the above are really needed or
or if just the CONFIG_NET_PCI option is needed.
I had enabled the option using a .cfg file. Also checking again to see if a warning
gets generated when the dependent options are not included.
BTW what does a message such as following in the .config file mean ?
"CONFIG_xxxxx is not set"
From: Bruce Ashfield [mailto:bruce.ashfield@...]
Sent: Wednesday, August 31, 2011 6:27 PM
To: Zanussi, Tom
Cc: Saxena, Rahul; yocto@...
Subject: Re: [yocto] e100 driver does not build
On 11-08-31 7:18 PM, Tom Zanussi wrote:
This is most likely what it is.
Out of curiosity, how did you enable the option ? Via a config fragement
(.cfg file) or via menuconfig .. or something else?
If you tried to set something via a fragment and it doesn't make it to
the final .config, you should see a warning during the kernel build