On 11-08-31 7:18 PM, Tom Zanussi wrote:

On Wed, 2011-08-31 at 16:04 -0700, Saxena, Rahul wrote:

I am unable to get the e100 driver to build for my BSP.

I have configured to build it as a module. I do not see the e100.ko
file being generated nor does

CONFIG_E100 appear in the generated .config file in my build area.



However I do see the driver source file e100.c in
tmp/work/bspname-poky-linux/linux-yocto-3.0.3+git1
+xxxx ../linux/drivers/net



I do not have any problems with other drivers (igb, E1000 etc) that I
have configured in exactly similar way.



Any insight on this issue ?

It's probably missing another option it depends on e.g. is
CONFIG_NET_PCI and CONFIG_MII enabled in your .config?

This is most likely what it is.

Out of curiosity, how did you enable the option ? Via a config fragement
(.cfg file) or via menuconfig .. or something else?

If you tried to set something via a fragment and it doesn't make it to
the final .config, you should see a warning during the kernel build
phase.

Cheers,

Bruce

Tom

Thanks

Rahul

_______________________________________________
yocto mailing list
yocto@...
https://lists.yoctoproject.org/listinfo/yocto