<div dir="ltr">Hello,<div><br></div><div>I'm attempting to build the picozed-zynq7 machine using meta-xilinx with Poky 2.4.2.  I've tried using the <i>rocko</i> branch as well as <i>rel-v2018.2</i>.  For the latter, I had to patch the machine definition since it was missing <i>require </i>(PR: <a href="https://github.com/Xilinx/meta-xilinx/pull/9">https://github.com/Xilinx/meta-xilinx/pull/9</a>).  My layer configuration is:</div><div><br></div><div><div>BBLAYERS ?= " \</div><div>  /ssd/yocto_projects/picozed/poky/meta \</div><div>  /ssd/yocto_projects/picozed/poky/meta-poky \</div><div>  /ssd/yocto_projects/picozed/poky/meta-xilinx/meta-xilinx-bsp \</div><div>  "</div></div><div><br></div><div>In each case, I can build <i>core-image-minimal</i>, however there is no console output on boot over the UART.  The D10 and D11 PS LEDs on the FMC carrier card are flashing in sync.</div><div><br></div><div>Has anyone else successfully built for this target recently?</div><div><br></div><div>Regards,</div><div><br></div><div>Thomas</div><div><br></div><div><br></div></div>